Invented by Digby Rowsell in 2004, TeleBeam is a unique lightweight structural system specifically designed for loft conversions
Our modern approach to loft conversions using lightweight aluminium beams means installation time is much shorter and simpler than traditional methods – you quickly benefit from extra space!
TeleBeam has been designed primarily for the retrospective conversion of existing modern roof trusses to provide habitable accommodation in the roof space. Depending on the project, it can also be adapted for use in traditional ‘cut roofs’ where it may be difficult to provide adequate support.
Sharing the load
Roof trusses work on a ‘Load Sharing’ principle in that each truss typically carries only a 600mm width of roof load. TeleBeam extends this concept further by employing two lightweight aluminium beams to help the truss carry its existing roof load, plus the additional floor load required as a result of the conversion. This approach minimises loss of headroom.
Telescopic beams
Lightweight and sustainably produced aluminium, TeleBeams are telescopic and adjust to the span of the building and work for any roof pitch. They span from outside wall to outside wall and do not rely on any internal support.
Maximising space
TeleBeam requires no temporary propping or support as it is installed entirely before any of the existing truss braces are cut out. The new vertical stud walls at the edge of the room transfer the roof load down to the TeleBeam system, and the remaining ceiling tie / joist of the original truss takes all of the horizontal loads to prevent any roof spread. The new floor is fixed directly to the TeleBeams, so no need for timber floor joists.